TUNNEL-TE/2/hwMplsApsDegraded_active

Message

TUNNEL-TE/2/hwMplsApsDegraded_active: Tunnel protection group receives an APS degraded alarm.(IfIndex=[WorkTunnelIfIndex], SessionTunnelId=[SessionTunnelId], LocalLspId=[LocalLspId], IngressLsrId=[IngressLsrId], EgressLsrId=[EgressLsrId],WorkTunnel=[WorkTunnel], SignalingProtocol=[SgnlPrtcl], SignalledTunnelName=[SignalledTunnelName])

Description

A alarm was generated when tunnel protection group receives an APS degraded.

Parameters

Parameter Name	Parameter Meaning
WorkTunnelIfIndex	Work Tunnel Interface Index
SessionTunnelId	Tunnel ID of a session
LocalLspId	LSP ID of a tunnel session
IngressLsrId	LSR ID of the ingress of a tunnel
EgressLsrId	LSR ID of the egress of a tunnel
WorkTunnel	Name of the working tunnel in a tunnel protection group
SgnlPrtcl	Signaling protocol used by a tunnel session including: 1: RSVP 2: STATIC 3: CRSTATIC
SignalledTunnelName	Tunnel alias.

Possible Causes

1.One tunnel in the protection group is faulty.

2.Lock is configured for protection group.

Procedure

1.Check the status of protection group, if locked, delete the configuration of lock.

2. Check the status of Tunnel APS protection group and Tunnel status, to determine whether there is a fault Tunnel.

If not, proceed to step 5.
If yes, go to step 3.

3. Check whether the corresponding port of the faulty tunnel is shut down.

If yes, open the closed port.
If no, proceed to Step 4.

4. Check whether the optical fiber of the port corresponding to the faulty tunnel is properly connected.

If yes, go to step 5.
If not, reconnect the fiber.

5. Collect log information and configuration information, and then contact technical support personnel.

6. End.