L2VPN/4/hwPWOverLdpOverGRENotSupportForwardAlarm_active

Message

L2VPN/4/hwPWOverLdpOverGRENotSupportForwardAlarm_active: The public network tunnel used to carry the VPLS PW or EVPN is a LDP over GRE tunnel and the VPLS PW or EVPN cannot forward traffic.(VsiName=[hwVplsOverLdpOverGreVsiName], RemoteIp=[hwPeerRemoteIp], PwId=[hwVplsOverLdpOverGrePwId], EvpnName=[hwEvpnOverLdpOverGreEvpnName])

In VS mode, this log is supported only by the admin VS.

Description

The public network tunnel used to carry the VPLS PW or EVPN is an LDP over GRE tunnel and the VPLS PW or EVPN cannot forward traffic.

Parameters

Parameter Name	Parameter Meaning
hwVplsOverLdpOverGreVsiName	VSI Name.
hwPeerRemoteIp	Remote IP.
hwVplsOverLdpOverGrePwId	PwId.
hwEvpnOverLdpOverGreEvpnName	EVPN Name.

Possible Causes

The VPLS PW or EVPN is carried over a LDP over GRE tunnel, and the signaling protocol status of the VPLS PW or EVPN is Up.

Procedure

1. Check whether the VSI or EVPN name is correct. Specifically, run the display vsi name vsi-number verbose command to check VSI information. In a VPLS scenario, identify the corresponding PW based on the remote IP address displayed in the alarm information and check whether Tnl Type is LDP over GRE. If it is LDP over GRE, run the display vsi name command to check the public network tunnel type.

If the tunnel is an LDP over GRE tunnel, go to Step 3.
If the tunnel is not an LDP over GRE tunnel, go to Step 2.

2. Run the tunnel-policy command to access the PW tunnel policy view and run the tunnel select-seq or tunnel binding TE command to change the public network tunnel to a non-LDP over GRE tunnel.

If the alarm is cleared, go to Step 4.
If the alarm is not cleared, go to Step 3.

3. Collect alarm, log, and configuration information, and contact technical support personnel.

4. End.