L2VPN/4/hwPbbEvpnNotSupportTunnelAlarm_active
Message
L2VPN/4/hwPbbEvpnNotSupportTunnelAlarm_active: The public network tunnel of PBB EVPN cannot forward traffic. (EvpnName=[hwNotSupportTunnelEvpnName], RemoteIp=[hwEVPNPeerRemoteIp], TunnelType=[hwNotSupportTunnelType])
In VS mode, this log is supported only by the admin VS.
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
|
hwNotSupportTunnelEvpnName |
EVPN Name. |
|
hwEVPNPeerRemoteIp |
Remote IP. |
|
hwNotSupportTunnelType |
Tunnel Type. |
Possible Causes
- Cause 1: The PBB EVPN is carried over a BGP tunnel, and the signaling protocol status of the PBB EVPN is up.
- Cause 2: The PBB EVPN is carried over a E2E-SRTE tunnel, and the signaling protocol status of the PBB EVPN is up.
- Cause 3: The PBB EVPN is carried over a TE over GRE tunnel, and the signaling protocol status of the PBB EVPN is up.
Procedure
1.Run the tunnel-policy command in system view to specify an LDP or TE tunnel in a tunnel policy. Then check whether the alarm is cleared.
- If yes, go to Step 4.
- If no, go to Step 2.
2.Run the tnl-policy bevpn command in the B-EVPN instance view to bind the B-EVPN instance to the specified tunnel policy. Then check whether the alarm is cleared.
- If yes, go to Step 4.
- If no, go to Step 3.
3.Collect trap, log, and configuration information, and contact technical support personnel.
4.End.