BRASAM/4/hwPoolGroupUsedIPReachThreshold_active
Message
BRASAM/4/hwPoolGroupUsedIPReachThreshold_active: The number of IP addresses in the IP pool group exceeds the threshold. (PoolGroupNo.=[PoolGroupNo],PoolGroupName=[PoolGroupName])
In VS mode, this log is supported only by the admin VS.
Description
The proportion of the consumed addresses in an address pool group to the total number of addresses was above the preset threshold, which is 80% by default.
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
|
PoolGroupNo |
Index ID of an address pool group. |
|
PoolGroupName |
Name of the address pool group. |
Possible Causes
The number of users getting online increased, causing the proportion of the consumed addresses in the address pool group to the total number of addresses to exceed the threshold.
Procedure
1.Run the ip-pool command in the relevant pool group view to bind a pool with a large number of idle addresses, or run the section section-num start-ip-address [ end-ip-address ] command to increase the number of addresses in the pool, and then check whether the alarm is cleared.
- If so, go to Step 3.
- If not, go to Step 2.
2.Collect alarm information, log information, and configuration information, and contact technical support personnel.
3.End.