RM/2/hwPublicIpv6PrefixExceed_active

Message

RM/2/hwPublicIpv6PrefixExceed_active: The number of public IPv6 prefixes exceeded the maximum value. (PrefixCount=[PrefixCount], MaxValue=[MaxValue])

Description

The number of IPv6 public route prefixes exceeded the maximum number that is allowed.

Parameters

Parameter Name	Parameter Meaning
PrefixCount	Number of IPv6 public route prefixes in the routing table
MaxValue	Maximum number of IPv6 public route prefixes that is allowed

Possible Causes

Cause1: A large number of IPv6 routes were added to the routing table.

Cause2: The maximum number of IPv6 public route prefixes that is allowed was decreased.

Procedure

1. Run the display ipv6 routing-table statistics command to check the total number of IPv6 public route prefixes and the number of routes of each routing protocol that are added to the IPv6 routing table. Then, run the display ipv6 routing-table limit command to check whether the number of IPv6 public route prefixes exceeds the configured maximum number.

If the number of IPv6 public route prefixes exceeds the configured maximum number, go to 2.
If the number of IPv6 public route prefixes is less than the configured maximum number, go to 3.

2. Delete unneeded IPv6 public routes or run the ipv6 prefix-limit number { alert-percent [ route-unchanged ] | simply-alert } command to increase the maximum number. Then, check whether the alarm persists.

If the alarm persists, go to 3.
If the alarm is cleared, go to 4.

3. Collect alarm information and configuration information, and then contact technical support personnel.

4. End.