FEI_APS/3/hwPwApsTunnelNonSupport_active

Message

FEI_APS/3/hwPwApsTunnelNonSupport_active: PW APS does not support the current public tunnel. (VcID=[VcID], VcType=[VcType], PeerAddr=[PeerAddr])

This log is supported only on NetEngine 8000 F1A.

Description

PW APS did not support the current public tunnel.

Parameters

Parameter Name	Parameter Meaning
VcID	ID of a VC
VcType	VC Type: 1: FR 2: ATM_AAL5 3: ATM_CELL_TRANSPORT 4: VLAN 5: ETHERNET 6: HDLC 7: PPP 8: CEM 9: ATM_CELL_VCC 10: ATM_CELL_VPC 11: IP_LAYER2_TRANSPORT 12: ATM_ONE_TO_ONE_VCC_CELL_MODE 13: ATM_ONE_TO_ONE_VPC_CELL_MODE 14: ATM_AAL5_PDU_VCC_TRANSPORT 15: FR_PORT 16: CEP 17: SAT_E1_OVER_PACKET 18: SAT_T1_OVER_PACKET 19: SAT_E3_OVER_PACKET 20: SAT_T3_OVER_PACKET 21: CESOPSN_BASIC_MODE 22: TDMOIP_AAL1 23: CESOPSN_TDM 24: TDMOIP_AAL2 25: FR_DLCI 26: INTERWORKING 27: VPLS 64: IP_INTERWORKING
PeerAddr	Peer IP address

Possible Causes

The PW bound to the APS instance was carried over a non-TE tunnel.

Procedure

1.Check the bearer tunnel type of the PW. In a VLL scenario, run the display mpls l2vc command to check the bearer tunnel type; in a VPLS scenario, run the display vsi name command to check the bearer tunnel type.

If the tunnel is a TE tunnel, go to Step 3.
If the tunnel is a non-TE tunnel, go to Step 2.

2.Configure a TE tunnel as the bearer tunnel. Then, check whether the alarm persists.

If the alarm is cleared, go to Step 4.
If the alarm is persists, go to Step 3.

3.Collect trap, log, and configuration information, and contact technical support personnel.

4.End.