L2IF/4/hwSlotMacLimitNumRaisingThreshold_active: MAC address learning based on SLOT reached the limit. (L2IfPort=[L2IfPort], MacLimitVlanId=[MacLimitVlanId], MacLimitVsiName=[MacLimitVsiName], entPhysicalIndex=[entPhysicalIndex], aseTrapSeverity=[aseTrapSeverity], BaseTrapProbableCause=[BaseTrapProbableCause], BaseTrapEventType=[BaseTrapEventType], MacDynAddressLearnNum=[MacDynAddressLearnNum], MacLimitMaxMac=[MacLimitMaxMac], SlotName=[SlotName], DeviceName=[DeviceName])
In VS mode, this log is supported only by the admin VS.
| Parameter Name | Parameter Meaning |
|---|---|
|
L2IfPort |
Interface name. |
|
MacLimitVlanId |
VLAN ID. |
|
MacLimitVsiName |
VSI name. |
|
entPhysicalIndex |
Interface index. |
|
aseTrapSeverity |
Alarm severity. |
|
BaseTrapProbableCause |
Alarm cause. |
|
BaseTrapEventType |
Alarm event type. |
|
MacDynAddressLearnNum |
Number of learned dynamic MAC addresses. |
|
MacLimitMaxMac |
Maximum number of MAC addresses that can be learned. |
|
SlotName |
Board name. |
|
DeviceName |
Device name. |
The number of MAC addresses learned per slot in the upstream direction reached the alarm threshold.
1.This trap message is informational only. To clear the alarm, go to Step 2.
2.Run the undo mac-address command in the system view to delete inapplicable MAC entries, or run the mac-limit rule-name maximum command in the system view to configure the maximum number of MAC addresses allowed to be learned if all application requirements are met. Then check whether the alarm is cleared.
3.Collect trap, log, and configuration information, and contact technical support personnel.
4.End.