After configuring a hard-pipe VPWS/VPLS PW, check the configurations.
Prerequisites
A hard-pipe VPWS/VPLS PW has been configured.
Procedure
- Run the display qos hard-pipe statistics interface interface-name outbound command to check hard pipe statistics of outgoing traffic on an interface.
- Run the display qos hard-pipe ability [ interface interface-name ] command to check the hard pipe mode supported on an interface.
- Run the display mpls static-l2vc hard-pipe [ brief | vc-id | interface interface-type interface-number | state { down | up } ] command to check hard-pipe static PW information.
- Run the display mpls switch-l2vc hard-pipe [ brief | ip-address vc-id encapsulation { atm-1to1-vcc | atm-1to1-vpc | atm-aal5-pdu | atm-aal5-sdu | atm-nto1-vcc | atm-nto1-vpc | atm-trans-cell | cesopsn-basic | ethernet | fr | hdlc | ip-interworking | ip-layer2 | ppp | satop-e1 | satop-e3 | satop-t1 | vlan } | state { down | up } ] command to check hard-pipe static MS-PW information.
- Run the display vsi [ name vsi-name ] [ verbose ] command. The command output shows hard-pipe static PW information of the VPLS.
- Run the display traffic-statistics vsi vsi-name hard-pipe [ peer peer-address [ negotiation-vc-id vc-id ] ] command. The command output shows hard-pipe static PW traffic statistics information of the VPLS.