Creating the L3VE Sub-interface Terminated by Dot1q

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface virtual-ethernet interface-type interface-number

   A L3VE sub-interface is created the sub-interface view is displayed.

3. Run control-vid vid dot1q-termination

   The sub-interface is encapsulated into the Dot1q termination mode.

4. Run dot1q termination vid low-pe-vid [ to high-pe-vid ]

   The Dot1q termination is configured for the L3VE sub-interface.

5. Run arp broadcast enable

   The ARP broadcast function is enabled for the sub-interface for Dot1q VLAN tag termination.

   When you enable or disable the ARP broadcast function on a termination sub-interface, the routing status of the sub-interface becomes Down and then Up. This may result in a flapping of routes on the entire network, affecting the normal operation of services.

6. Run ip binding vpn-instance vpn-instance-name

   The L3VE sub-interface is associated with a VPN instance.

7. Run ip address ip-address { mask | mask-length }

   The IP address is configured.

   

   The IP address is a private network address of MPLS L3VPN.

8. Run commit

   The configuration is committed.