Establishing Route Reflection for BGP VPNv6 Routes

This section describes how to configure route reflection for BGP VPNv6 routes so that the RR can reflect the VPNv6 routes received from a client PE to other client PEs.

Procedure

Run system-view
The system view is displayed.
Run bgp as-number
The BGP view is displayed.
Run ipv6-family vpnv6
The BGP-VPN IPv6 address family view is displayed.
Run either of the following commands:
- To enable route reflection if the RR has established an MP-IBGP connection to a peer group consisting of all the client PEs, run the peer group-name reflect-client command.
- To enable route reflection if the RR has established an MP-IBGP connection to each client PE rather than a peer group, run the peer peer-ipv4-address reflect-client command.
Run undo policy vpn-target
The function to filter received VPNv6 routes based on VPN targets is disabled.
(Optional) Run rr-filter extcomm-filter-name
A reflection policy is configured for the RR. To allow an RR to filter routes to be reflected, run the rr-filter command. Only IBGP routes of which the RT extended community attribute matches the reflection policy can be reflected.
Run commit
The configuration is committed.