Using Ping/Tracert on a VPN Network

Using Ping to Monitor Link Connectivity on a VLL Network

This section describes how to check the communication among PEs on a VLL network through the ping operation.

Using Tracert to Test the Forwarding Path on a VLL Network

This section describes how to check the communication among PEs on a VLL network through the tracert operation.

Using Tracert to Test the Forwarding Path on a PWE3 Network

You can run the tracert command to obtain information about the SPEs and Ps through which packets pass from the source to the destination. Based on the command output, you can monitor PW connectivity and locate faulty nodes.

Using Ping to Monitor PW Connectivity on a VPLS Network

After you configure a virtual private LAN service (VPLS) network, use pseudo wire (PW) ping to monitor PW connectivity on the VPLS network.

Using Tracert to Test the Forwarding Path on a VPLS Network

Using Ping to Monitor PW Connectivity on a VPWS Network

After you configure a virtual private wire service (VPWS) network, use pseudo wire (PW) ping to monitor PW connectivity on the VPWS network.

Using Ping to Test VPLS MAC Connectivity

You can perform a ping operation to check the connectivity of Layer 2 forwarding links on the VPLS network by specifying the MAC address and VSI name.

Using Ping to Monitor Link Connectivity on a EVPN VPLS Network

You can perform a ping operation to check tunnel connectivity on an EVPN VPLS network by specifying a MAC address.

Using Ping to Monitor Link Connectivity on an EVPN VPWS Network

A ping operation can be performed to check EVPN VPWS network connectivity.

Using Tracert to Test the Forwarding Path on an EVPN VPWS Network

A tracert operation can be performed to locate an EVPN VPWS tunnel forwarding fault.

Using CE Ping to Monitor the Connectivity Between a PE and a CE on a VPLS Network

After you configure a virtual private LAN service (VPLS) network, use customer edge (CE) ping to monitor the connectivity between a provider edge (PE) and a CE on the VPLS network.

Using CE Ping to Check the Connectivity Between a PE and a CE in an EVC Model

After configuring a Bridge Domain (BD), you can use CE ping to check the connectivity between a PE and a CE in an Ethernet Virtual Connection (EVC) model.

Using CE Ping to Check the Connectivity Between a PE and a CE

After configuring an EVPN, you can use CE ping to check the connectivity between a PE and a CE.