(Optional) Configuring a RIP Preference

When there are routes discovered by multiple routing protocols on the same device, you can set a preference for RIP to control the route selection result.

Procedure

Run system-view
The system view is displayed.
Run rip [ process-id ]
A RIP process is created, and the RIP view is displayed.
Run preference { preference | { route-policy route-policy-name | route-filter route-filter-name } } ^* A preference is set for RIP.
The preference command can be used together with a route-policy to set a preference for the matched routes.

If the RIP preference is changed after RIP routing information is delivered to the routing management (RM) module, the RM module re-updates the routing table.
Run commit
The configuration is committed.