Debugging RIP

Routers can generate associated debugging information after you enable the debugging of modules in the user view. Debugging information displays the contents of the packets sent or received by the debugged modules.

Context

Debugging affects system performance. Therefore, after debugging, run the undo debugging all command to disable it immediately.

When a RIP fault occurs, run any of the following debugging commands in the user view to debug RIP and locate the fault.

For detailed procedure of displaying the debugging information, see "Information Center Configuration" in the HUAWEI NetEngine 8000 F SeriesRouter Configuration Guide - System Management.

Procedure

  1. Run the debugging rip process-id packet [ send | receive ] [ error ] [ verbose] [ interface interface-type interface-number [ peer peer-address ] ] command to debug the RIP packets sent or received on the network.
  2. Run the debugging rip process-id route [ error | backup ] [ imported | { interface interface-type interface-number [ peer peer-address ] } ] command to debug RIP routes.
  3. Run the debugging rip miscellaneous command to debug RIP packets globally.
Parent Topic: Maintaining RIP
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic