Configuring an E2E SR-MPLS TE Tunnel Interface

Procedure

1. Run system-view

   The system view is displayed.

2. Run interface tunnel tunnel-number

   An inter-AS E2E tunnel interface is created, and the tunnel interface view is displayed.

3. Run either of the following commands to assign an IP address to the tunnel interface:

   • To configure an IP address for the tunnel interface, run the ip address ip-address { mask | mask-length } [ sub ] command.

     The secondary IP address of the tunnel interface can be configured only after the primary IP address is configured.

   • To configure the tunnel interface to borrow the IP address of another interface, run the ip address unnumbered interface interface-type interface-number command.

   

   The SR-MPLS TE tunnel is unidirectional and does not need a peer IP address. A separate IP address for the tunnel interface is not recommended. Use the LSR ID of the ingress as the tunnel interface's IP address.

4. Run tunnel-protocol mpls te

   MPLS TE is configured as a tunneling protocol.

5. Run destination ip-address

   A tunnel destination address, which is usually the LSR ID of the egress, is configured.

   Various types of tunnels require specific destination addresses. If a tunnel protocol is changed from another protocol to MPLS TE, a configured destination address is deleted automatically and a new destination address needs to be configured.

6. Run mpls te tunnel-id tunnel-id

   A tunnel ID is set.

7. Run mpls te signal-protocol segment-routing

   Segment Routing is configured as the signaling protocol of the TE tunnel.

8. Run mpls te pce delegate

   PCE server delegation is enabled so that the controller can compute paths.

9. (Optional) Run match dscp { ipv4 | ipv6 } { default | { dscp-value [ to dscp-value ] } &<1-32> }

   DSCP values are configured for IPv4/IPv6 packets to enter the SR-MPLS TE tunnel.

   The DSCP configuration and mpls te service-class command configuration of an SR-MPLS TE tunnel are mutually exclusive.

10. Run commit

    The configuration is committed.