Verifying the Configuration of an Inter-AS E2E SR-MPLS TE Tunnel

After configuring an inter-AS E2E SR-MPLS TE tunnel, verify information about the SR-MPLS TE tunnel and its status statistics.

Prerequisites

The inter-AS E2E SR-MPLS TE tunnel has been configured.

Procedure

  1. Run the display mpls te tunnel [ destination ip-address ] [ lsp-id lsr-id session-id local-lsp-id | lsr-role { all | egress | ingress | remote | transit } ] [ name tunnel-name ] [ { incoming-interface | interface | outgoing-interface } interface-type interface-number ] [ verbose ] command to check tunnel information.
  2. Run the display mpls te tunnel-interface [ tunnel tunnel-number ] command to check information about a tunnel interface on the ingress.
  3. Run the display mpls te binding-sid [ label label-value ] command to check the mapping between binding SIDs and tunnels.
Parent Topic: Configuring an Inter-AS E2E SR-MPLS TE Tunnel (Path Computation on the Controller)
Copyright © Huawei Technologies Co., Ltd.
Copyright © Huawei Technologies Co., Ltd.
< Previous topic