Configuring SR-MPLS Flex-Algo LSP Traffic Statistics Collection

This section describes how to configure SR-MPLS Flex-Algo LSP traffic statistics collection.

Context

Traffic statistics collection for an SR-MPLS Flex-Algo LSP helps you collect statistics about the traffic forwarded through the SR-MPLS Flex-Algo LSP.

Procedure

Run the system-view command to enter the system view.
Run the segment-routing command to enter the Segment Routing view.
Run the traffic-statistics flex-algo exclude { flex-algo-begin [ to flex-algo-end ] } &<1-10> command to enable traffic statistics collection for a specified SR-MPLS Flex-Algo LSP.
By default, traffic statistics collection is enabled for all SR-MPLS Flex-Algo LSPs. You can use flex-algo-begin [ to flex-algo-end ] to exclude some Flex-Algo LSPs that do not require traffic statistics collection.
Run the commit command to commit the configuration.

Verifying the Configuration

After configuring SR-MPLS Flex-Algo LSP traffic statistics collection, verify the configuration.

Run the display segment-routing traffic-statistics [ ip-address mask-length ] [ flex-algo [ flexAlgoId ] ] [ verbose ] command to check SR-MPLS BE traffic statistics.

Follow-up Procedure

To clear SR-MPLS Flex-Algo LSP traffic statistics before re-collection, run the reset segment-routing traffic-statistics [ ip-address mask-length ] flex-algo [ flexAlgoId ] command.