Configuring Static VPWS Accessing VPLS

Procedure

1. Configure SVC VPWS.
2. Configure static VPLS.
   1. Configure static VPLS.
   2. (Optional) Run mac-withdraw enable and interface-status-change [ up | down ] mac-withdraw enable

      MAC Withdraw is enabled.

      If you do not perform this step, a traffic forwarding error may occur before MAC addresses are aged out.

   3. (Optional) Run local-mac remove all-but-mine

      The device is enabled to delete MAC addresses except those associated with the PW over which the device receives a MAC Withdraw message with the TLV type 0x404.

      If you do not perform this step, the device will delete all MAC addresses when receiving a MAC Withdraw message with the TLV type 0x404.

   4. (Optional) Run vpls mac-withdraw loop-detect enable

      MAC Withdraw loop detection is enabled.

      A MAC Withdraw loop detection-capable device forwards MAC Withdraw messages with the Path TLV inserted. A MAC Withdraw loop detection-incapable device forwards MAC Withdraw messages without inserting the Path TLV.

   5. Run commit

      The configuration is committed.