Indicates the numbers of the card and device where
resources are exhausted.
Possible Causes
1. VFP entry resources are exhausted.
2. The
operation of adding the VFP entry is incorrect.
Procedure
Run the display acl resource command to check whether VLAN ACL or VACL resources are exhausted.
If so, go to step 2.
If not, go to step 4.
Run the display acl resource [ slotslot ] command to view information about ACL
resources, including ACL4 and ACL6 resources.
Run the display current-configuration command to
check the current configuration on the switch.
Check the services that occupy ACL resources based on ACL
resource information and the current configuration as follows, and
delete unnecessary services to release ACL resources.
Check whether NAC, IPSG, MQC, and ACL-based simplified traffic
policy services that occupy a large amount of ACL resources exist
on the switch.
Check the services that occupy ACL resources based on fields in
the ACL resource information. For example, MQC, ACL-based simplified
traffic policy, SVF, MPLS,
and BFD for VPLS services occupy UDF ACL resources. If
a large amount of UDF ACL resources are occupied, check these
services first.
Reconfigure a VSI and check whether the problem is rectified.
If the problem is not rectified, go to step 6.
Collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.