display alarm manual-clear

Function

The display alarm manual-clear command displays the alarms that are not reported repeatedly after being cleared.

Format

display alarm manual-clear

Parameters

None

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

After the mask manual-clear alarm command is executed to prevent manually cleared active alarms from being reported repeatedly and then the clear alarm active command or MIB table hwAlarmActiveTable is used to manually clear active alarms, you can run the display alarm manual-clear command to view the active alarms that are not reported repeatedly after being cleared.

Example

# Display the alarms that are not reported repeatedly after being cleared.

<HUAWEI> display alarm manual-clear
A/B/C/D/E/F/G/H/I/J
A=Sequence, B=RootKindFlag(Independent|RootCause|nonRootCause)
C=Generating time, D=Clearing time
E=ID, F=Name, G=Level, H=State
I=Description information for locating(Para info, Reason info)
J=RootCause alarm sequence(Only for nonRootCause alarm)

  2/Independent/2016-05-04 10:38:46-08:00/-/0xff14280c/hwEntityOffline/Major/Start/ OID 1
.3.6.1.4.1.2011.5.25.129.2.1.13 Physical entity changed to the offline state. (E
ntityPhysicalIndex=16842752, BaseTrapSeverity=5, BaseTrapProbableCause=69120, Ba
seTrapEventType=5, EntPhysicalContainedIn=16777216, EntPhysicalName="LPU slot 1"
, RelativeResource="", ReasonDescription="Because of get offline message, the en
tity of SLOT1 changed to offline state")

**Table 1** Description of the **display alarm manual-clear** command output
Item	Description
A/B/C/D/E/F/G/H/I/J	Alarm display format
A=Sequence	Alarm sequence number.
B=RootKindFlag(Independent\|RootCause\|nonRootCause)	Flag indicating a root-cause alarm or a non-root-cause alarm: Independent: indicates an alarm for which alarm correlation analysis is not performed. RootCause: indicates a root-cause alarm. nonRootCause: indicates a non-root-cause alarm.
C=Generating time	Time when an alarm is generated.
D=Clearing time	Time when an alarm is cleared.
E=ID	Alarm ID.
F=Name	Alarm name.
G=Level	Alarm severity. To set this parameter, run the alarm-name severity command.
H=State	Alarm status: Start End
I=Description information for locating(Para info, Reason info)	Alarm description.
J=RootCause alarm sequence(Only for nonRootCause alarm)	Sequence number of a root-cause alarm (for non-root-cause alarms only)