The dot1x trigger dhcp-binding command enables the device to automatically generate the DHCP snooping binding table after static IP users pass 802.1X authentication or when the users are at the pre-connection phase.
The undo dot1x trigger dhcp-binding command restores the default setting.
By default, the device does not automatically generate the DHCP snooping binding table after static IP users pass 802.1X authentication or when the users are at the pre-authentication phase.
Ethernet interface view, GE interface view, XGE interface view, 40GE interface view, Eth-Trunk interface view
This command is available to aid upgrade compatibility. It can only be run during the configuration restoration phase of the upgrade.
After the upgrade, this command is no longer supported, and it is replaced by the dot1x trigger dhcp-binding command in the dot1x access profile view.