BRASAM_1.3.6.1.4.1.2011.6.8.2.2.0.3 hwAllocUserIPFailAlarm

Trap Buffer Description

Fail to alloc IP address from domain. (DomainNo.=[DomainNo],DomainName=[DomainName])

No IP address in the domain can be assigned to users.

In VS mode, this trap is supported only by the admin VS.

This alarm is supported only on NetEngine 8000 F1A.

Trap Attributes

Trap Attribute	Description
Alarm or Event	Event
Trap Severity	Warning
Mnemonic Code	hwAllocUserIPFailAlarm
Trap OID	1.3.6.1.4.1.2011.6.8.2.2.0.3
MIB	HUAWEI-IPPOOL-MIB
Alarm ID	This is an event trap and does not involve alarm ID.
Alarm Name	This is an event trap and does not involve alarm name.
Alarm Type	This is an event trap and does not involve alarm type.
Raise or Clear	This is an event trap and does not involve alarm generation or clearance.
Match trap	-

Trap Buffer Parameters

Parameter	Description
DomainNo	Index of a domain.
DomainName	Name of a domain.

VB Parameters

VB OID	VB Name	VB Index
1.3.6.1.4.1.2011.6.8.1.1.1.1	hwIPPoolIndex	hwIPPoolIndex
1.3.6.1.4.1.2011.6.8.1.1.1.2	hwIPPoolName	hwIPPoolIndex

Impact on the System

The IP addresses in the address pool of the domain were used up. Therefore, the user failed to obtain an IP address and thus cannot go online.

Possible Causes

The IP addresses in the address pool of the domain were used up because there were excessive access users.

Procedure

1. Run the display domain name command to check whether an IP address pool is bound to the domain and whether the IP-address-pool-name field is displayed.

If not, configure an IP address pool. For details, see the Configuration Guide - BRAS.
If an IP address pool is configured, go to Step 2.

2. Run the display ip pool name command to check the idle field. If the value of the Idle field is 0, no IP address segment is available in the address pool. In this case, go to Step 3.

3. Run the section command in the corresponding address pool view or run the ip-pool command in the domain view to add an address pool and increase the number of IP addresses.

4. Check whether the alarm is cleared.

If yes, go to Step 6.
If no, go to Step 5.

5. Collect alarm, log, and configuration information, and contact technical support personnel.

6. End.