Interface output flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwIfMonitorOutputRatePercentage], TrapThreshold=[hwIfMonitorOutputRateThreshold], InterfaceName=[InterfaceName])
The trap was generated when the percentage of the rate of sent traffic to the total bandwidth on an interface was greater than the threshold.
In VS mode, this trap is supported only by the admin VS.
| Trap Attribute | Description |
|---|---|
Alarm or Event |
Alarm |
Trap Severity |
Warning |
Mnemonic Code |
hwIfMonitorOutputRateRising |
Trap OID |
1.3.6.1.4.1.2011.5.25.41.4.7 |
MIB |
HUAWEI-IF-EXT-MIB |
Alarm ID |
0x081300af |
Alarm Name |
hwIfMonitorOutputRateRising |
Alarm Type |
processingErrorAlarm |
Raise or Clear |
Raise |
Match trap |
DEVM_1.3.6.1.4.1.2011.5.25.41.4.8 hwIfMonitorOutputRateResume |
| Parameter | Description |
|---|---|
IfIndex |
Specifies an interface index. |
hwIfMonitorOutputRatePercentage |
Indicates statistics on outgoing traffic. |
hwIfMonitorOutputRateThreshold |
Specifies an alarm threshold for outgoing traffic. |
InterfaceName |
Specifies an interface name. |
| VB OID | VB Name | VB Index |
|---|---|---|
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.10 |
hwIfMonitorOutputRate |
hwIfMonitorIndex |
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.11 |
hwIfMonitorOutputRateThreshold |
hwIfMonitorIndex |
1.3.6.1.4.1.2011.5.25.41.1.7.1.1.19 |
hwIfMonitorName |
hwIfMonitorIndex |
1. Run the display this interface command on the interface to check whether the traffic threshold is too low. The threshold range is specified by users according to actual services.
2. Run the trap-threshold output-rate bandwidth-in-use command to re-set the threshold and then check whether the alarm is cleared.
3. Collect alarm information and configuration information, and then contact technical support personnel.
4. End.