diameter monitor-key

Function

The diameter monitor-key command configures a Diameter monitoring key in a service policy.

The undo diameter monitor-key command deletes a Diameter monitoring key configured in a service policy.

By default, no Diameter monitoring key is configured in a service policy.

This command is supported only on the NetEngine 8000 F1A.

Format

diameter monitor-key monitor-key

undo diameter monitor-key [ monitor-key ]

Parameters

Parameter	Description	Value
monitor-key	Specifies a Diameter monitoring key.	The value is an integer that ranges from 1 to 4294967294.

Parameter

Description

Value

monitor-key

Specifies a Diameter monitoring key.

The value is an integer that ranges from 1 to 4294967294.

Views

Service policy view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
vas	write

Usage Guidelines

Usage Scenario

To configure a Diameter monitoring key in a service policy, run the diameter monitor-key command. After the command is run, the device checks whether the monitoring key in a received Diameter quota is the same as the configured Diameter monitoring key. If they are different, the device does not process the quota.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Set a Diameter monitoring key to 20 in a service policy.

<HUAWEI> system-view
[~HUAWEI] service-policy name test edsg
[*HUAWEI-service-policy-test] commit
[~HUAWEI-service-policy-test] diameter monitor-key 20