esqm protocol tcp enable

Function

The esqm protocol tcp enable command enables a device from performing ESQM for Transmission Control Protocol (TCP) packets.

The undo esqm protocol tcp enable command disables a device to perform ESQM for TCP packets.

By default, after ESQM is enabled on a device, the device will not perform ESQM for TCP packets.

This command is supported only on the NetEngine 8000 F1A.

Format
Parameters
Views
Default Level
Task Name and Operations
Usage Guidelines
Example

Format

esqm protocol tcp enable

undo esqm protocol tcp enable

Parameters

None

Views

Enhanced stream quality monitoring view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
esqm	write

Usage Guidelines

Usage Scenario

After ESQM is enabled on a device, the device will not perform ESQM for TCP packets by default. To enable the device from performing ESQM for TCP packets, run the esqm protocol tcpenable command.

Example

# Enable a device from performing ESQM for TCP packets.

<HUAWEI> system-view
[~HUAWEI] esqm
[~HUAWEI-esqm] esqm protocol tcp enable