l2tp lns protocol-packet soft-transmit enable

Function

The l2tp lns protocol-packet soft-transmit enable command enables an LNS to transmit L2TP packets to an LAC by software.

The undo l2tp lns protocol-packet soft-transmit enable command disables an LNS from transmitting L2TP packets to an LAC by software.

By default, an LNS is disabled from transmitting L2TP packets to an LAC by software.

This command is supported only on the NetEngine 8000 F1A.

Format

l2tp lns protocol-packet soft-transmit enable

undo l2tp lns protocol-packet soft-transmit enable

Parameters

None

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
l2tp	write

Usage Guidelines

Usage Scenario

To enable an LNS to transmit L2TP packets to an LAC by software, run the l2tp lns protocol-packet soft-transmit enable command. Software-based forwarding uses per-packet load balancing to prevent packets from arriving out of order.

After an LNS is disabled from transmitting L2TP packets to an LAC by software, L2TP protocol packets are forwarded by hardware between the LNS's tunnel board and the LNS's forwarding VM connecting to an LAC.

Prerequisites

The device has been configured as a LNS. The command does not take effect for non-LNS devices.

Example

# Enable an LNS to transmit L2TP packets to an LAC by software.

<HUAWEI> system-view
[~HUAWEI] l2tp lns protocol-packet soft-transmit enable