loop-detect trigger min-port-uptime

Function

The loop-detect trigger min-port-uptime command configures the system to start proactive loop detection on an interface after a specified period elapses since the interface status changes from Down to Up.

The undo loop-detect trigger min-port-uptime command restores the default configuration.

By default, the system starts proactive loop detection 10 minutes after a Down interface goes Up.

Format

loop-detect trigger min-port-uptime min-port-uptime

undo loop-detect trigger min-port-uptime [ min-port-uptime ]

Parameters

Parameter	Description	Value
min-port-uptime	Indicates the minimum interval between the time when the interface goes Down and the time when the interface goes Up.	The value is an integer that ranges from 1 to 100, in minutes.

Parameter

Description

Value

min-port-uptime

Indicates the minimum interval between the time when the interface goes Down and the time when the interface goes Up.

The value is an integer that ranges from 1 to 100, in minutes.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
vlan	write

Usage Guidelines

Usage Scenario

If the minimum interval at which an interface changes from Down to Up does not meet the requirement, you can run this command to set the desired interval.

Configuration Impact

The minimum interval at which an interface changes from Down to Up is changed.

Example

# Restore the default value.

<HUAWEI> system-view
[~HUAWEI] loop-detect trigger min-port-uptime 10