nat alarm user-table threshold

Function

The nat alarm user-table threshold command sets the alarm threshold for the total number of user tables.

The undo nat alarm user-table threshold command restores the default alarm threshold for the total number of user tables.

The default alarm threshold of user tables is 80%.

This command is supported only on the NetEngine 8000 F1A.

Format

nat alarm user-table threshold threshold-value

undo nat alarm user-table threshold [ threshold-value ]

Parameters

Parameter	Description	Value
threshold threshold-value	Specifies the alarm threshold of user tables.	The value is an integer ranging from 60 to 90, in percentage. The default value is 80.

Parameter

Description

Value

threshold threshold-value

Specifies the alarm threshold of user tables.

The value is an integer ranging from 60 to 90, in percentage. The default value is 80.

Views

System view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
nat	write

Usage Guidelines

Usage Scenario

To set the alarm threshold of the total number of user tables, run the nat alarm user-table threshold command. If user table usage reaches the alarm threshold, a service board sends an alarm to the NMS.

Prerequisites

The trap or log function has been enabled for user tables using the nat alarm user-table command.

Configuration Impact

If user table usage reaches the specified alarm threshold, the service board sends an alarm to the NMS. If user table usage exceeds the alarm threshold, the service board does not repeatedly send an alarm. After user table usage falls to 87.5%, the service board sends a clear alarm to the NMS.

Precautions

In VS mode, this command is supported only by the admin VS.

Example

# Set the alarm threshold for user table usage to 85%.

<HUAWEI> system-view
[~HUAWEI] undo nat alarm user-table log disable
[~HUAWEI] nat alarm user-table threshold 85