peer signaling vpws (BGP-L2VPN-AD address family view)

Format

peer ipv4-address signaling vpws

undo peer ipv4-address signaling vpws

Parameters

Parameter	Description	Value
ipv4-address	Specifies the IPv4 address of a peer. The loopback address of a peer is usually used as its IPv4 address.	The value is in dotted decimal notation.

Parameter

Description

Value

ipv4-address

Specifies the IPv4 address of a peer. The loopback address of a peer is usually used as its IPv4 address.

The value is in dotted decimal notation.

Views

BGP-L2VPN-AD address family view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
bgp	write

Usage Guidelines

Usage Scenario

In remote BGP VPWS connection scenarios, the VPWS signaling mode must be enabled in the L2VPN AD address family view for BGP peers to exchange VPWS routes. To configure the VPWS signaling mode for a specified peer, run the peer signaling vpws command.

Prerequisites

A peer has been enabled using the peer enable command.

Precautions

The signaling mode configured for a peer takes precedence over the signaling mode configured for the peer group to which the peer belongs. If no signaling mode is configured for a peer but a signaling mode is configured for the peer group to which the peer belongs, the peer uses the signaling mode configured for the peer group.

Example

# Configure the BGP VPWS signaling mode for peer 10.1.1.1 in the L2VPN AD address family view.

<HUAWEI> system-view
[~HUAWEI] bgp 100
[*HUAWEI-bgp] peer 10.1.1.1 as-number 100
[*HUAWEI-bgp] l2vpn-ad-family
[*HUAWEI-bgp-af-l2vpn-ad] peer 10.1.1.1 enable
[*HUAWEI-bgp-af-l2vpn-ad] peer 10.1.1.1 signaling vpws