tunnel idle-cut

Function

The tunnel idle-cut command sets the idle-cut time of the L2TP tunnel.

The undo tunnel idle-cut command restores the default value.

By default, the idle-cut time of the L2TP tunnel is 60 seconds.

This command is supported only on the NetEngine 8000 F1A.

Format

tunnel idle-cut time-value

undo tunnel idle-cut

Parameters

Parameter	Description	Value
time-value	Specifies the idle-cut time of the tunnel in seconds.	The value is an integer ranging from 0 to 100000, in seconds. Zero indicates that the local end will never clear the tunnel.

Parameter

Description

Value

time-value

Specifies the idle-cut time of the tunnel in seconds.

The value is an integer ranging from 0 to 100000, in seconds. Zero indicates that the local end will never clear the tunnel.

Views

L2TP group view

Default Level

2: Configuration level

Task Name and Operations

Task Name	Operations
l2tp	write

Usage Guidelines

Usage Scenario

When the idle-cut time of the L2TP tunnel is set to 0, it indicates that the local end will never clear the tunnel. However, if the tunnel is cleared by the peer end, the tunnel cannot be re-established any more.

Precautions

In the scenario where 1:1 inter-board backup is configured on the L2TP LNS, if a tunnel board is unbound from a backup group, the deletion of the tunnels on the tunnel board will be delayed. During the period when the deletion is delay, the tunnel idle-cut function does not take effect.

Example

# Set the idle-cut time of the L2TP tunnel to be 100 seconds.

<HUAWEI> system-view
[~HUAWEI] l2tp-group huawei
[*HUAWEI-l2tp-huawei] tunnel idle-cut 100