DEVM/1/hwChassisFail_active-131353

Message

DEVM/1/hwChassisFail_active: The chassis failed partially. (EntityPhysicalIndex=[EntityPhysicalIndex], EntPhysicalIndex=[EntPhysicalIndex], EntPhysicalName=[EntPhysicalName], EntityTrapFaultID=131353, Reason=The cable of SFU area is not stable.)

This log is supported only on NetEngine 8000 F1A.

In VS mode, this log is supported only by the admin VS.

Description

The chassis experienced a partial failure.

Parameters

Parameter Name	Parameter Meaning
EntityPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalIndex	Indicates the index of the physical entity.
EntPhysicalName	Indicates the name of the physical entity, such as chassis.
EntityTrapFaultID	Indicates the error code.
ReasonDescription	Indicates the description of the cause of the trap.

Possible Causes

Fan backplane cable of SFU area is not stable

Procedure

If this alarm occurs, the fans in the SFU area cannot work properly.

1. Remove and then insert the faulty fan located in the SFU area.When the fan is registered, check whether the alarm is cleared.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 2.

2. Contact technical support personnel. and check whether the SFU area cable for the fan backplane is securely inserted.

If the alarm is cleared, go to Step 4.
If the alarm persists, go to Step 3.

3. Collect trap, log, and configuration information, and contact technical support.

4. End.