Configuring PPPoEv6 Access

Configuring an Address Assignment Mode

The address assignment modes supported by the NetEngine 8000 F include NDRA, DHCPv6 (IA_NA), DHCPv6 (IA_PD), DHCPv6 (IA_NA)+PD (IA_PD), and NDRA+DHCPv6 (IA_PD). You can configure an address assignment mode as required.

Configuring a Virtual Template

Layer 2 protocols cannot directly carry each other. Before configuring PPPoE access, create a virtual template (VT).

Binding the Virtual Template to an Interface

Bind a VT to an interface so that data on the interface can be transmitted based on parameters defined in the VT.

Binding a Sub-interface to a VLAN

To restrict broadcast packets on a LAN and enhance LAN security or create virtual groups, configure VLANs. VLANs apply only to Ethernet sub-interfaces.

Configuring a BAS Interface

If an interface is used for broadband user access, you must configure it as a BAS interface and set an access type and other attributes.

(Optional) Configuring Refined IPv6 Route Advertisement

Refined IPv6 route advertisement can classify routes and advertise them to different networks.

(Optional) Enabling URPF for PPP Users

Enabling URPF for PPP users prevents source address spoofing attacks.

(Optional) Configuring the PPP Magic Number Check Function

You can configure the PPP magic number check function to check whether a PPPoE user stays online after the user logs in.

Verifying the PPPoEv6 Access Configuration

After configuring PPPoEv6 access, verify the configuration.