This section describes how to configure a manual switching mechanism for a primary/hot-standby CR-LSP. This mechanism allows you to control primary/hot-standby CR-LSP switchovers using commands.
When a primary CR-LSP needs to be adjusted, you can switch the traffic to the hot-standby CR-LSP using the hotstandby-switch force command. After the primary CR-LSP has been adjusted, you can switch back the traffic to the primary CR-LSP using the hotstandby-switch clear command.
The system view is displayed.
The view of the MPLS TE tunnel interface is displayed.
A manual switching mechanism for the primary/hot-standby CR-LSP is configured.
If you specify force, the traffic switches temporarily to the hot-standby CR-LSP. If you specify clear, the traffic switches back to the primary CR-LSP.