Configuration Examples for IPv4 Static Routes

Example for Configuring IPv4 Static Routes

You can configure IPv4 static routes to interconnect any two devices on an IPv4 network.

Example for Configuring IPv4 Floating Static Routes

IPv4 Floating static routes can be used for the static route backup.

Example for Configuring Dynamic BFD for IPv4 Static Routes

Dynamic BFD for IPv4 static routes can fast detect link failures.

Example for Configuring Static BFD for IPv4 Static Routes

To improve network reliability, you can configure static BFD for IPv4 static routes to fast detect link failures and speed up route convergence.

Example for Associating EFM with IPv4 Static Routes

After EFM is associated with IPv4 static routes, the system responds to the interface Up or Down event that is triggered by the change of the EFM OAM extension status and determines whether to activate static routes. This mechanism controls route advertisement and ensures that the traffic from the remote end can be correctly forwarded.

Example for Configuring FRR for IPv4 Static Routes on the Public Network

FRR for IPv4 static routes on the public network can fast detect link failures.

Example for Configuring Association between LDP and Static Routes

On an MPLS network with primary and secondary LSPs established by LSRs using static routes, association between LDP and static routes prevents traffic from being interrupted during traffic switchover or switchback.