Table 1 describes the Y.1731 configuration tasks.
Scenario |
Description |
Task |
|---|---|---|
Configure single-ended frame loss measurement in a VLAN |
On the VLAN networking where CFM is enabled, if CCMs cannot be sent for connectivity check, deploy single-ended frame loss measurement to check the packet loss rate on a link, monitoring the link quality. |
Configuring Single-ended Frame Loss Measurement in VLAN Networking |
Configure dual-ended frame loss measurement in a VLAN |
On the VLAN networking where CFM is enabled, if precise statistics about the packet loss rate need to be collected, deploy dual-ended frame loss measurement to check the packet loss rate on a link, monitoring the link quality. |
Configuring Dual-ended Frame Loss Measurement in VLAN Networking |
Configure one-way frame delay measurement |
When CFM is enabled and clocks of the MEPs at both ends of a link are synchronized, deploy one-way frame delay measurement to measure the network delay time on a unidirectional link between MEPs. |
|
Configure two-way frame delay measurement |
When CFM is enabled and clocks of the MEPs at both ends of a link are not synchronized, deploy two-way frame delay measurement to measure the network delay time on a bidirectional link between MEPs. |
|
Configure single-ended SLM in a VLAN |
To collect packet loss statistics on a point-to-multipoint link, you can configure single-ended SLM. |
|
Configure AIS |
AIS suppresses the MEP of the high-level MD from sending traps to the NMS. |
|
Configuring Multicast MAC Ping |
Identifies faults and discovers RMEPs. |