Configuration Examples for Bit-Error-Triggered Protection Switching

Example for Configuring Bit-Error-Triggered Section Switching

This section provides an example for configuring bit-error-triggered section switching.

Example for Configuring the Association Between Bit Errors and IGP Routes

Example for Configuring Bit-Error-Triggered Trunk Update

This section provides an example for configuring bit-error-triggered trunk update.

Example for Configuring Bit-Error-Triggered RSVP-TE Tunnel Switching

This section provides an example for configuring bit-error-triggered Resource Reservation Protocol-Traffic Engineering (RSVP-TE) tunnel switching.

Example for Configuring Bit-Error-Triggered PW Switching

This section provides an example for configuring bit-error-triggered pseudo wire (PW) switching.

Example for Configuring Bit-Error-Triggered L3VPN Route Switching

This section provides an example for configuring bit-error-triggered Layer 3 virtual private network (L3VPN) route switching.

Example for Configuring Bit-Error-Triggered EVPN L3VPN Route Switching

This section provides an example for configuring bit-error-triggered EVPN L3VPN route switching.

Example for Configuring Bit-Error-Triggered Protection Switching on an NG MVPN

This section provides an example for configuring bit-error-triggered protection switching in an NG MVPN scenario.

Example for Associating MAC-Layer SD Alarms with E-PW APS

In E-PW APS scenarios, MPLS-TP OAM is used to monitor the status of a static single-segment (SS) PW. An E-Trunk is configured to determine the master/backup PE status. This section provides an example for associating MAC-layer SD alarms with E-PW APS.